Search results
Results from the WOW.Com Content Network
The millimetre (SI symbol: mm) is a unit of length in the metric system equal to 10 −3 metres ( 1 / 1 000 m = 0.001 m). To help compare different orders of magnitude , this section lists lengths between 10 −3 m and 10 −2 m (1 mm and 1 cm).
Mommes (mm), traditionally used to measure silk fabrics, the weight in pounds of a piece of fabric if it were sized 45 inches by 100 yards (1.2 m by 90 m). One momme = 4.340 g/m 2; 8 mommes is approximately 1 ounce per square yard or 35 g/m 2.
To convert to an expression for crystal size in terms of the peak width in the scattering angle used in X-ray powder diffraction, we note that the scattering vector = (/) (/), where the here is the angle between the incident wavevector and the scattered wavevector, which is different from the in the scan.
a very fine grain of sand (0.063 mm diameter, 3 micrograms) 1 × 10 −12: One nanolitre 6.2 × 10 −11: A medium grain of sand (0.5 mm diameter, 1.5 milligrams) 5 × 10 −10: Volume of a poppy seed of 1-millimetre diameter [1] 1 × 10 −9: One cubic millimetre or one microlitre: 4 × 10 −9: Volume of a mustard seed of 2-millimetre ...
Vernier caliper scales; main at top, vernier at bottom. It reads 3.58 ± 0.02 mm by adding 3.00 mm (left red mark) on the fixed main scale to vernier 0.58 mm (right red mark). The main scale reading is that to the left of the zero on the vernier scale. The vernier reading is found by locating the best aligned lines between the two scales.
A thousandth of an inch is a derived unit of length in a system of units using inches.Equal to 1 ⁄ 1000 of an inch, a thousandth is commonly called a thou / ˈ θ aʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils).
Sedimentation time is longest for the finest particles, so this technique is useful for sizes below 10 μm, but sub-micrometer particles cannot be reliably measured due to the effects of Brownian motion. Typical apparatus disperses the sample in liquid, then measures the density of the column at timed intervals.
Watt called his instrument a micrometer, a term now used with a different meaning in engineering (the micrometer screw gauge). It consisted of two parallel hairs in the focal plane of a telescope eyepiece crossing an upright hair. At the point to be measured, two sliding targets on a surveyor's rod were adjusted to align with the hairs in the ...