Search results
Results from the WOW.Com Content Network
A superabsorbent polymer (SAP) (also called slush powder) is a water-absorbing hydrophilic homopolymers or copolymers [1] that can absorb and retain extremely large amounts of a liquid relative to its own mass. [2] Water-absorbing polymers, which are classified as hydrogels when mixed, [3] absorb aqueous solutions through hydrogen bonding with ...
It is a common observation that when oil and water are poured into the same container, they separate into two phases or layers, because they are immiscible.In general, aqueous (or water-based) solutions, being polar, are immiscible with non-polar organic solvents (cooking oil, chloroform, toluene, hexane etc.) and form a two-phase system.
The reaction results in a polymer which is also soluble in the chosen solvent. Heat released by the reaction is absorbed by the solvent, reducing the reaction rate. Moreover, the viscosity of the reaction mixture is reduced, preventing autoacceleration at high monomer concentrations. A decrease in viscosity of the reaction mixture by dilution ...
Super-absorbent polymers (SAP) similar to sodium polyacrylate were developed in the 1960s by the U.S. Department of Agriculture. [3] Before the development of these substances, the best water absorbing materials were cellulosic or fiber-based like tissue paper, sponge, cotton, or fluff pulp.
In a liquid-liquid interface with monomer dissolved in one phase, polymerization occurs on only one side of the interface, whereas in liquid-liquid interfaces with monomer dissolved in both phases, polymerization occurs on both sides. [2] An interfacial polymerization reaction may proceed either stirred or unstirred.
Exposing the polymer solution to a vapor of anti-solvent; Evaporating the solvent in atmospheric air or at high temperature; The rate at which phase inversion occurs and the characteristics of the resulting membrane are dependent on several factors, including: [2] Solubility of solvent in the anti-solvent; Insolubility of the polymer in the ...
In materials science, liquefaction [1] is a process that generates a liquid from a solid or a gas [2] or that generates a non-liquid phase which behaves in accordance with fluid dynamics. [3] It occurs both naturally and artificially. As an example of the latter, a "major commercial application of liquefaction is the liquefaction of air to ...
A small amount of superabsorbent polymer material is taken (0.1g) and it is placed in the beaker. 100 ml of deionized water is poured into the beaker. After 20 min the swollen polymer was separated by using [filter paper] By weighing the polymer, one can find the swollen capacity of the SAP material. [3]