enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Electrical outlet tester - Wikipedia

   en.wikipedia.org/wiki/Electrical_outlet_tester

   A receptacle tester being used to check for some types of improper wiring of an outlet. For this particular tester, proper wiring is indicated by the two yellow lights. The outlet tester checks that each contact in the outlet appears to be connected to the correct wire in the building's electrical wiring. It can identify several common wiring ...

3. Residual-current device - Wikipedia

   en.wikipedia.org/wiki/Residual-current_device

   A residual-current device (RCD), residual-current circuit breaker (RCCB) or ground fault circuit interrupter (GFCI) [a] is an electrical safety device, more specifically a form of Earth-leakage protection device, that interrupts an electrical circuit when the current passing through a conductor is not equal and opposite in both directions, therefore indicating leakage current to ground or ...

4. Recloser - Wikipedia

   en.wikipedia.org/wiki/Recloser

   Single Wire Earth Return Network Protection: SWER network design topology is discouraged in modern electrical engineering due to safety reasons, but due to cost savings it is sometimes deployed. Single Phase Reclosers can be used to improve safety on these lines during fault events. Single Phase Recloser Single Phase Laterals Overcurrent Protection

5. Split-phase electric power - Wikipedia

   en.wikipedia.org/wiki/Split-phase_electric_power

   Single-pole circuit breakers feed 120 V circuits from one of the 120 V buses within the panel, or two-pole circuit breakers feed 240-volt circuits from both buses. 120 V circuits are the most common, and used to power NEMA 1 and NEMA 5 outlets, and most residential and light commercial direct-wired lighting circuits.

6. Electrical safety testing - Wikipedia

   en.wikipedia.org/wiki/Electrical_safety_testing

   Live testing. Earth fault loop impedance testing: this test is to check that if a fault did occur, that the system meets requirements to cause a disconnection of the supply within the time limit specified by standards Insulation resistance testing Polarity test: a test to check that the connections are connected in the right sequence

7. Multiway switching - Wikipedia

   en.wikipedia.org/wiki/Multiway_switching

   These switches appear externally similar to single pole, single throw (SPST) switches, but have extra connections which allow a circuit to be controlled from multiple locations. Toggling the switch disconnects one "traveler" terminal and connects the other. Electrically, a typical "3-way" switch is a single pole, double throw (SPDT) switch. By ...