Ad
related to: drilled displacement piles treatment
Search results
Results from the WOW.Com Content Network
An Olivier pile is a drilled displacement pile:. [1] This is an underground deep foundation pile made of concrete or reinforced concrete with a screw-shaped shaft ( helical shaft ) which is performed without soil removal.
Also called caissons, drilled shafts, drilled piers, cast-in-drilled-hole piles (CIDH piles) or cast-in-situ piles, a borehole is drilled into the ground, then concrete (and often some sort of reinforcing) is placed into the borehole to form the pile. Rotary boring techniques allow larger diameter piles than any other piling method and permit ...
Franki piles can be used as high-capacity deep foundation elements without the necessity of excavation or dewatering. [4] They are useful in conditions where a sufficient bearing soil can only be reached deeper in the ground, [5] [6] and are best suited to granular soil where bearing is primarily achieved from the densification of the soil around the base. [4]
Once initial piles are set with concrete, other shafts are augured between them, slicing into the original piles, with the new ones receiving rebar. The finished result is a continuous wall of reinforced concrete that aids and protects workers during excavation. [citation needed]
Not knowing the applied treatment, past use, or if diesel fuels have been applied to the surface used to give the appearance of a recent retreatment could decrease the life of the pile. Some unscrupulous suppliers of used timber piles should be avoided, because some contractors have applied diesel fuel to the outside of the piles to bring the ...
Tracked vehicle configured as a dedicated pile driver. A pile driver is a heavy-duty tool used to drive piles into soil to build piers, bridges, cofferdams, and other "pole" supported structures, and patterns of pilings as part of permanent deep foundations for buildings or other structures. Pilings may be made of wood, solid steel, or tubular ...
Shoring is commonly used when installing the foundation of a building. A shoring system such as piles and lagging or shotcrete will support the surrounding loads until the underground levels of the building are constructed. Commonly used shoring equipment includes post shores, shoring beams, and timber jacks.
Tiebacks are drilled into soil using a small diameter shaft, and usually installed at an angle of 15 to 45 degrees. [2] [1] They can be either drilled directly into a soldier pile, or through a wale installed between consecutive piles. Grouted tiebacks can be constructed as steel rods drilled through a concrete wall out into the soil or bedrock ...
Ad
related to: drilled displacement piles treatment