Search results
Results from the WOW.Com Content Network
In commercial power plants, there are two to four steam generators per reactor; each steam generator can measure up to 70 feet (21 m) in height and weigh as much as 800 tons. Each steam generator can contain anywhere from 3,000 to 16,000 tubes, each about .75 inches (19 mm) in diameter.
Single pressure HRSGs have only one steam drum and steam is generated at a single pressure level, whereas multi pressure HRSGs employ two (double pressure) or three (triple pressure) steam drums. As such, triple pressure HRSGs consist of three sections: an LP (low pressure) section, a reheat/IP (intermediate pressure) section, and an HP (high ...
It has two water/steam drums. The low-pressure drum is connected to the low-pressure economizer or evaporator. The low-pressure steam is generated in the low temperature zone of the turbine exhaust gasses. The low-pressure steam is supplied to the low-temperature turbine. A super heater can be provided in the low-pressure circuit.
Collects steam at the top of the boiler (well above the water level) so that it can be fed to the engine via the main steam pipe, or dry pipe, and the regulator/throttle valve. [2] [5] [6]: 211–212 [3]: 26 Air pump / Air compressor Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system.
The mixture of steam and water is led by the upper steam lines, one for each pressure channel, from the reactor top to the steam separators, pairs of thick horizontal drums located in side compartments above the reactor top; each has 2.8 m (9 ft 2 in) diameter, 31 m (101 ft 8 in) length, wall thickness of 10 cm (3.9 in), and weighs 240 t (260 ...
Steam generator (auxiliary boiler), a steam-powered boiler used on ships to produce a low-pressure steam, heated by a high-pressure steam supply rather than a flame. Steam generator (boiler), an oil- or gas-fired boiler, based on a low-water content monotube coil. Steam generator (nuclear power), a heat exchanger in a pressurized water nuclear ...
The exhaust pressure is controlled by a regulating valve to suit the needs of the process steam pressure. These are commonly found at refineries, district heating units, pulp and paper plants, and desalination facilities where large amounts of low pressure process steam are needed.
Although the definitions are somewhat flexible, it can be said that older steam generators were commonly termed boilers and worked at low to medium pressure (7–2,000 kPa or 1–290 psi) but, at pressures above this, it is more usual to speak of a steam generator. A boiler or steam generator is used wherever a source of steam is required.