Search results
Results from the WOW.Com Content Network
Starting with the 1986 model year, the AMC straight-4 engines used a throttle body injection (TBI) or single-point, fuel injection system with a new fully computerized engine control. [3] In addition to cycling the fuel injector (pulse-width time, on–off), the engine control computer also determined the ignition timing, idle speed, exhaust ...
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The early 2.1 L (128 cu in) Renault turbodiesel I4 used its specific control setup. The Jeep Wrangler (YJ) did not get the AMC 4.0 L I6 engine until 1991, when Chrysler-designed electronics accompanied it. Until then, it retained the AMC 258 cu in (4.2 L) engine with a carburetor. No other Jeep vehicle was equipped with Renix electronic controls.
An ECU from a Geo Storm An electronic control unit ( ECU ), also known as an electronic control module ( ECM ), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle .
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Dashboard instruments displaying various car and engine conditions. Where the dashboard originally included an array of simple controls (e.g., the steering wheel) and instrumentation to show speed, fuel level and oil pressure, the modern dashboard may accommodate a broad array of gauges, and controls as well as information, climate control and entertainment systems.
The new Cherokee (KL) is built on the compact U.S. wide platform, and features a nine-speed automatic, a choice of a 2.4 L Tigershark I4 with Fiat's electro-hydraulic MultiAir 2 variable valve timing and variable valve lift or a 3.2 L V6 based on the Pentastar 3.6 L V6, and front and four-wheel drive (the latter a Jeep's Selec-Terrain system). [55]
The gross power and torque outputs decreased to 72 hp (54 kW; 73 PS) and 112 lb⋅ft (152 N⋅m), respectively, when the engine had a 6.9:1 compression ratio. Bore and stroke dimensions were the same as the L-head engine at 3 + 1 ⁄ 8 x 4 + 3 ⁄ 8 inches, giving 134.2 cu in (2,199 cc). [3] The F4-134 was introduced in 1950 in the Jeep Truck. [4]