Search results
Results from the WOW.Com Content Network
Its schematic can be seen in figure 1. It is an inverting converter, so the output voltage is negative with respect to the input voltage. The main advantage of this converter is the continuous currents at the input and output of the converter. The main disadvantage is the high current stress on the switch. [4] Fig. 1: Cuk converter circuit diagram.
A boost converter or step-up converter is a DC-to-DC converter that increases voltage, while decreasing current, from its input to its output . It is a class of switched-mode power supply (SMPS) containing at least two semiconductors, a diode and a transistor , and at least one energy storage element: a capacitor , inductor , or the two in ...
A power converter is an electrical device for converting electrical energy between alternating current (AC) and direct current (DC). It can also change the voltage or frequency of the current. Power converters include simple devices such as transformers, and more complex ones like resonant converters.
A buck converter or step-down converter is a DC-to-DC converter which decreases voltage, while increasing current, from its input to its output . It is a class of switched-mode power supply . Switching converters (such as buck converters) provide much greater power efficiency as DC-to-DC converters than linear regulators , which are simpler ...
And because the bandwidth of a BJT depends on current, the bandwidth of log-antilog converters varies with signal amplitude and drops to near zero as the signal amplitude drops. Log converters have been claimed to be inferior to using modern high-resolution delta-sigma modulation analog-to-digital converters and performing calculations ...
] Because capacitor C1 blocks direct current (DC), the average current through it (I C1) is zero, making inductor L2 the only source of DC load current. Therefore, the average current through inductor L2 (I L2) is the same as the average load current and hence independent of the input voltage. Looking at average voltages, the following can be ...
Most single phase alternating-current electrical outlets in the world supply power at 210–240 V or at 100–120 V. A transformer or autotransformer can be used; (auto)transformers are inherently reversible, so the same transformer can be used to step the voltage up, or step it down by the same ratio.
Other buck circuits exist to boost the average output current with a reduction of voltage. In a SMPS, the output current flow depends on the input power signal, the storage elements and circuit topologies used, and also on the pattern used (e.g., pulse-width modulation with an adjustable duty cycle) to drive the