enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   These nails were known as cut nails because they were produced by cutting iron bars into rods; they were also known as square nails because of their roughly rectangular cross section. The cut-nail process was patented in the U.S. by Jacob Perkins in 1795 and in England by Joseph Dyer, who set up machinery in Birmingham. The process was designed ...

3. Penny (unit) - Wikipedia

   en.wikipedia.org/wiki/Penny_(unit)

   A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.

4. Go/no-go gauge - Wikipedia

   en.wikipedia.org/wiki/Go/no-go_gauge

   Hardened and ground plug gauge Replaceable thread and plug gauges. These gauges are referred to as plug gauges; they are used in the manner of a plug.They are generally assembled from standard parts, where the gauge portion is interchangeable with other gauge pieces (obtained from a set of pin type gauge blocks) and a body that uses the collet principle to hold the gauges firmly.

5. Gauge (instrument) - Wikipedia

   en.wikipedia.org/wiki/Gauge_(instrument)

   The gauge is placed against the edge to be checked and any light leakage between the blade and edge indicates a mismatch that requires correction. Ring gauge: a cylindrical ring of steel whose inside diameter is finished to gauge tolerance and is used for checking the external diameter of a cylindrical object. Strain gauge

6. Nail gun - Wikipedia

   en.wikipedia.org/wiki/Nail_gun

   Nail guns vary in the length and gauge (thickness) of nails they can drive. Air compressor supplies air into a nail gun. The smallest size of fasteners are normally 23 gauge (0.025 inches or 0.64 millimetres in diameter), commonly called "pin nailers" and generally have only a minimal head.

7. Marking gauge - Wikipedia

   en.wikipedia.org/wiki/Marking_gauge

   A marking gauge, also known as a scratch gauge, [1] is used in woodworking and metalworking to mark out lines for cutting or other operations. [2] The purpose of the gauge is to scribe a line parallel to a reference edge or surface. It is used in joinery and sheetmetal operations.

8. Nail clipper - Wikipedia

   en.wikipedia.org/wiki/Nail_clipper

   A variety of nail clippers; the clipper on the left is in the plier style; the centre and right clippers are in the compound lever style. A nail clipper (also called nail clippers, a nail trimmer, a nail cutter or nipper type) is a hand tool used to trim fingernails, toenails and hangnails.

9. Gauge (knitting) - Wikipedia

   en.wikipedia.org/wiki/Gauge_(knitting)

   The machine's gauge is expressed by the number of needles needed to achieve that gauge. B – Used for hand, mechanical, or modern Electronic Flat Machines (Stoll, Shima, Protti, etc.), where gauge is measured in 1-inch (2.5 cm) increments. The machine's gauge is again measured by the number of needles required to achieve that number.