Search results
Results from the WOW.Com Content Network
Biscuits are predominantly used in joining sheet goods such as plywood, particle board and medium-density fibreboard. They are sometimes used with solid wood, replacing mortise and tenon joints, as biscuit joints are easier to make and almost as strong. They are also used to align pieces when joined edge-to-edge in making wider panels.
However, α=45° will be stronger than α=90° if shear strength is greater than σ/2. The joint is strongest between these two angles at 63.4°. The joint becomes stronger than 63.4° at 25.4°. At a shallow enough angle, strength of the joint continues to increase and failure will occur anywhere in the two pieces, most likely outside the joint.
A dovetail joint or simply dovetail is a joinery technique most commonly used in woodworking joinery (carpentry), including furniture, cabinets, [1] log buildings, and traditional timber framing. Noted for its resistance to being pulled apart, also known as tensile strength, the dovetail joint is commonly used to join the sides of a drawer to ...
Molded plywood is the term for two- or three-dimensionally shaped products from multiple veneer layers that are glued together through heat and pressure in a pressing tool. The veneer layers are arranged crosswise at an angle of 90 degrees. Molded wood is used for flat furniture components such as seats, backrests and seat shells.
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
The joining technology is used in any type of mechanical joint which is the arrangement formed by two or more elements: typically, two physical parts and a joining element. The mechanical joining systems make possible to form a set of several pieces using the individual parts and the corresponding joining elements.
A screw is then inserted through an opposing slot and tightened to create a pull effect. This type of join is a very common joint in factory-made furniture. Mitre joint: Similar to a butt joint, but both pieces have been beveled (usually at a 45-degree angle). Box joint: A corner joint with interlocking square fingers.
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles