Search results
Results from the WOW.Com Content Network
There is an axial combustion chamber between the compressor stages and the HP turbine. A mixer is built in to the jetpipe to mix cold bypass air with the hot exhaust gases. The engine has an overall pressure ratio of 35:1, which is extremely high for an engine with a
The GE Passport is a high bypass ratio turbofan. The engine is a twin-spool, axial-flow turbofan with a high bypass ratio of 5.6:1 and an overall pressure ratio of 45:1. The front fan is attached to the three-stage low-pressure compressor; the 23:1 pressure ratio 10-stage high-pressure compressor includes five blisk stages for weight reduction.
The original engine contained a single stage fan driven by a 4-stage low pressure (LP) turbine, supercharging a 14-stage high pressure (HP) compressor driven by a 2-stage HP turbine, with an annular combustor. Later higher thrust versions of the CF34 feature an advanced technology core, with only 10 HP compressor stages.
The -5 model was certified in 1982, and a decade later, an engine utilizing the TFE731-5 power section and a TFE731-3 fan was built and designated the TFE731-4, intended to power the Cessna Citation VII aircraft. [4] The most recent version is the TFE731-50, based on the -60 used on the Falcon 900DX, which underwent its flight test program in ...
The American Federal Aviation Administration certified the engine for commercial operation on January 4, 2006. [4] The engine was ground run for the first time on an A380 on August 14, 2006, in Toulouse. [5] On August 25, 2006, the same aircraft, A380-861 test aircraft (MSN 009), made the first flight of an Engine Alliance powered A380.
Derived from the General Electric GE90 with a larger fan, advanced materials like ceramic matrix composites (CMCs), and higher bypass and compression ratios, it was designed to improve fuel efficiency by 10% compared to the GE90. It is rated at 110,000 lbf (490 kN) of thrust, which is 5,000 lbf (20 kN) less than the GE90 highest thrust variant ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
GEnx on 747-8I prototype. As of 2016, the GEnx and the Rolls-Royce Trent 1000 were selected by Boeing following a run-off between the three big engine manufacturers. The GEnx uses some technology from the GE90 turbofan, [1] including swept composite fan blades and the 10-stage high-pressure compressor (HPC) featured in earlier variants of the engine.