Search results
Results from the WOW.Com Content Network
Message Signaled Interrupts (MSI) are a method of signaling interrupts, using special in-band messages to replace traditional out-of-band signals on dedicated interrupt lines. While message signaled interrupts are more complex to implement in a device, they have some significant advantages over pin-based out-of-band interrupt signalling, such ...
High speed mode is still designed to reduce power usage due to its low voltage signaling and parallel transfer ability. The communication protocol describes two sets of instructions. The Display Command Set (DCS) is a set of common commands for controlling the display device, and their format is specified by the DSI standard.
GSM (Global System for Mobile Communications) is a set of standards for cell phone networks established by the European Telecommunications Standards Institute and first used in 1991. Its procedures refers to the steps a GSM network takes to communicate with cell phones and other mobile devices on the network.
[Note 4] Should the page or search for the subscriber fail, the VLR will indicate the failure cause to the VMSC, which will abort the Short Message delivery procedure and return the failure to the SMSC (see the Failed Short Message delivery section below). If the page of the handset was successful, the VMSC will then send to the SMSC indicating ...
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
With multiple sub devices, a multidrop configuration requires an independent CS signal from the main for each sub device, while a daisy-chain configuration only requires one CS signal. Every sub on the bus that has not been selected should disregard the input clock and MOSI signals.
Every signaling system can be characterized along each of the above axes of classification. A few examples: DTMF is an in-band, channel-associated register signaling system. It is not compelled. SS7 (e.g., TUP or ISUP) is an out-of-band, common-channel signaling system that incorporates both line and register signaling.
Initiator (INT) – This is the device that initiates a signaling procedure. Acceptor (ACP) – This is the device that shall respond to an incoming request from the INT; Note: the roles are not fixed to the devices. The roles are determined when you initiate a signaling procedure, and they are released when the procedure ends.