Search results
Results from the WOW.Com Content Network
Therefore John Joyce's research into low NO x burners revolved primarily around surface combustion techniques. Another issue was the effect combustion temperatures have on the formation of NO x . John Joyce's task became even more challenging when he decided not to direct his development towards radiant type surface combustion tiles.
Another method of fuel staged combustion is fuel biasing. In fuel biasing, combustion is staged by diverting fuel from the upper-level burners to the lower ones or from the center to the side burners. The aim is to create a fuel-rich lower or central zone and a fuel-lean upper or side zone in order to achieve complete burnout.
The amount of NOx produced depends on the combustion temperature. [2] When the combustion takes place at a lower temperature the NOx emissions are reduced. [ 2 ] Gas turbines with DLE technology were developed to achieve lower emissions without using water or steam to reduce combustion temperature (Wet Low Emission (WLE) technology).
The main drawback of lean-burning is that a complex catalytic converter system is required to reduce NOx emissions. Lean-burn engines do not work well with modern 3-way catalytic converter—which require a pollutant balance at the exhaust port so they can carry out oxidation and reduction reactions—so most modern engines tend to cruise and ...
This usually means that the evaporator section of the HRSG will have to be split and the SCR placed in between the two sections. Some low-temperature NOx catalysts have recently come to market that allow for the SCR to be placed between the evaporator and economizer sections (350–500 °F [177–260 °C]). [1] Packaged HRSG
The fuel efficiency and working principle of a PPC engine resemble those of Diesel engine, but the PPC engine can be run with a variety of fuels. Also, the partially premixed charge burns clean. [6] Challenges with using gasoline in a PPC engine arise due to the low lubricity of gasoline and the low cetane value of gasoline.
T-s diagram for the ideal/real ORC. The working principle of the organic Rankine cycle is the same as that of the Rankine cycle: the working fluid is pumped to a boiler where it is evaporated, passed through an expansion device (turbine, [3] screw, [4] scroll, [5] or other expander), and then through a condenser heat exchanger where it is finally re-condensed.
Propane burner with a Bunsen flame Oxy-Acetylene for cutting through steel rails Flame of a gas and oil, in a dual burner. A gas burner is a device that produces a non-controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and ...