Search results
Results from the WOW.Com Content Network
Sectioned 3-speed manual 'crash' gearbox, for a car c. 1935. A layshaft is an intermediate shaft within a gearbox that carries gears, but does not transfer the primary drive of the gearbox either in or out of the gearbox. [1] [2] Layshafts are best known through their use in car gearboxes, where they were a ubiquitous part of the rear-wheel ...
Three-speed sliding-gear non-synchronous transmission Non-synchronous "crash" gearbox; commonly used today in semi-trucks and tractors, and formerly used in automobiles pre-1950s. A non-synchronous transmission, also called a crash gearbox, is a form of manual transmission based on gears that do not use synchronizing mechanisms. They require ...
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...
The selector is typically symmetric: it slides between two gears and has a synchromesh and teeth on each side in order to lock either gear to the shaft. Unlike some other types of clutches (such as the foot-operated clutch of a manual-transmission car), a dog clutch provides non-slip coupling and is not suited to intentional slipping.
Top and side view, with Hurst shifter. The Toploader comprises two components: the main case, which encloses the gears, input and counter shaft, and the tailhousing, which encloses the speedometer gear and output shaft. The main case measures 10" in length, while the tailhousing measures 14", 15 1 ⁄ 2" or 17", depending on the application.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.
Most shaft-drive systems consist of a drive shaft (also called a "propeller shaft" or Cardan shaft) extending from the transmission in front to the differential in the rear. The differentiating characteristic of the Hotchkiss drive is the fact that the axle housing is firmly attached to the leaf springs to transfer the axle torque through them ...
The operation of a dual-clutch transmission is analogous to two traditional manual transmissions, each with its own clutch, operating in parallel and alternating shifts. The Ford unit is a six-speed with one clutch acting on reverse, first, third, and fifth gears, and the other used for second, fourth, sixth gears.