Search results
Results from the WOW.Com Content Network
Waterproofing conducted on the exterior of a freeway tunnel. Waterproofing is the process of making an object, person or structure waterproof or water-resistant so that it remains relatively unaffected by water or resisting the ingress of water under specified conditions. Such items may be used in wet environments or underwater to specified depths.
Waterproofing a structure from the exterior is the only method the U.S. International Building Code (IBC) recognizes as adequate to prevent structural damage caused by water intrusion. Waterproofing an existing basement begins with excavating to the bottom sides of the footings. Once excavated, the walls are then power washed and allowed to dry.
Rising damp is the effect of water rising from the ground into property. [3] The damp proof course may be horizontal or vertical. [4] A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material applied to prevent moisture transmission.
Bituminous waterproofing systems are designed to protect residential and commercial buildings. Bitumen (asphalt or coal-tar pitch) is a material made up of organic liquids that are highly sticky, viscous , and waterproof. [ 1 ]
In areas with high evaporation rates, this process often takes place overnight when temperatures are cooler. Once the pores are saturated as much as possible with water, the coating is applied. Hydrophobic chemicals are in a powder form and mixed with water at a ratio of five parts powder to two parts water for application by brush.
It is best practice to delay replastering and redecoration for as long as possible following rising damp treatment, but this obviously creates inconvenience to the occupants of the affected building. BRE Digest 245 states that "While the wall should be allowed to dry for as long as possible, replastering can follow, providing porous decorations ...
Sedimentation (water treatment) Septic tank; Septic tank conversion [2] Sequencing batch reactor; Sewage treatment; Skimmer (machine) Slow sand filter; Stabilization pond; Supercritical water oxidation (SCWO) Thermal hydrolysis; Treatment pond; Trickle-bed reactor; Trickling filter; Ultrafiltration; Ultraviolet disinfection; Upflow anaerobic ...
Flood control channels are large and empty basins where surface water can flow through but is not retained (except during flooding), or dry channels that run below the street levels of some larger cities, so that if a flash flood occurs the excess water can drain out along these channels into a river or other bodies of water. Flood channels are ...