Search results
Results from the WOW.Com Content Network
The clock rate of a CPU is normally determined by the frequency of an oscillator crystal. Typically a crystal oscillator produces a fixed sine wave —the frequency reference signal. Electronic circuitry translates that into a square wave at the same frequency for digital electronics applications (or, when using a CPU multiplier , some fixed ...
BogoMips is a value that can be used to verify whether the processor in question is in the proper range of similar processors, i.e. BogoMips represents a processor's clock frequency as well as the potentially present CPU cache. It is not usable for performance comparisons among different CPUs. [4]
For a given processor, C is a fixed value. However, V and f can vary considerably. For example, for a 1.6 GHz Pentium M, the clock frequency can be stepped down in 200 MHz decrements over the range from 1.6 to 0.6 GHz. At the same time, the voltage requirement decreases from 1.484 to 0.956 V.
Processor / System Dhrystone MIPS or MIPS, and frequency D instructions per clock cycle D instructions per clock cycle per core Year Source LINKS-1 Computer Graphics System (257-processor) 642.5 MIPS at 10 MHz: 2.5: 0.25: 1982 [98] Sega System 16 (4-processor) 16.33 MIPS at 10 MHz: 4.083: 1.020: 1985 [99] Namco System 21 (10-processor) 73.927 ...
The frequency at which a processor (CPU) operates is determined by applying a clock multiplier to the front-side bus (FSB) speed in some cases. For example, a processor running at 3200 MHz might be using a 400 MHz FSB. This means there is an internal clock multiplier setting (also called bus/core ratio) of 8. That is, the CPU is set to run at 8 ...
In PCs, the CPU's external address and data buses connect the CPU to the rest of the system via the "northbridge". Nearly every desktop CPU produced since the introduction of the 486DX2 in 1992 has employed a clock multiplier to run its internal logic at a higher frequency than its external bus, but still remain synchronous with it. This ...
The average of Cycles Per Instruction in a given process (CPI) is defined by the following weighted average: := () = () Where is the number of instructions for a given instruction type , is the clock-cycles for that instruction type and = is the total instruction count.
The final result comes from dividing the number of instructions by the number of CPU clock cycles. The number of instructions per second and floating point operations per second for a processor can be derived by multiplying the number of instructions per cycle with the clock rate (cycles per second given in Hertz) of the processor in question ...