Search results
Results from the WOW.Com Content Network
Connectors usually used for computer fans are the following: Three-pin Molex connector KK family This Molex connector is used when connecting a fan to the motherboard or other circuit board. It is a small, thick, rectangular in-line female connector with two polarizing tabs on the outer-most edge of one long side.
Inside a gaming case during gameplay. 360° photograph. A full tower case. Accessories shown include: a fan controller, a DVD burner, and a USB memory card reader.. Cases can come in many different sizes and shapes, which are usually determined by the form factor of the motherboard since it is physically the largest hardware component in most computers. Consequently, personal computer form ...
Increasing the voltage [4] over the default 12 V can be achieved by e.g. connecting the −12 V or −5 V power line instead of the ground wire in the fan connector, and by connecting the 5 V power line in the +12 V input of the fan connector. Through this procedure, 10, 17 and 24 V voltages can be achieved, with voltages exceeding 12 V being ...
When so upgraded, the repurposed fan would be connected to the motherboard's case fan connector (3-pin) while the new CPU fan would be connected to the motherboard's CPU fan connector (4-pin). AOpen Inc. produced a stackable S120 [26] case, allowing the user to stack up to four components vertically or horizontally. These layers can be for add ...
A finned air cooled heatsink with fan clipped onto a CPU, with a smaller passive heatsink without fan in the background A 3-fan heatsink mounted on a video card to maximize cooling efficiency of the GPU and surrounding components Commodore 128DCR computer's switch-mode power supply, with a user-installed 60 mm cooling fan.
An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...
Another common method for internal case modding uses the power outlet for the internal fan by splitting the cord with a "Y" connector. However, the most up to date modders will use power points under where the PSU (power supply) plugs in, which doesn't diminish any (or very little) power from the console.
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.