Search results
Results from the WOW.Com Content Network
A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...
Three different international-standard two-hole punches. A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves).
The compound tool differs from progressive and stage tools by the arrangement of the punch and die. It is an inverted tool where blanking and piercing takes place in a single stage and also the blanking punch will act as the piercing die. That means punch will be to the bottom side of the tool and piercing punches to top side of the tool.
Multiple punches may be used together to create a part in one step. Usually, the punch and die are close to the same dimensions, creating a sheared edge when they meet. A punch that is significantly smaller than the die can be used to produce an extruded hole where the punch displaces the punched material to the sides, forming a tube ...
Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.
A punch press is a type of machine press used to cut holes in material. It can be small and manually operated and hold one simple die set, or be very large, CNC operated, with a multi-station turret and hold a much larger and complex die set.
A leather punch is a hole punch specifically for making holes in leather. The working tip of the punch is a hollow steel cylinder with a sharp circular knife-like edge. The leather piece is placed on a hard surface, which may be a part of the tool set, and the punch is forced through it, cutting out a small circular piece which is discarded.
The Adell and Starrett mechanism uses a sliding block crosswise through the hammer rather than an intermediate pin. The hammer has a hole through its center that the top of the punch sits in, and holds the top of the punch centered. The sliding block has a hole through it that, when reset, is misaligned with the hole through the hammer.