Search results
Results from the WOW.Com Content Network
USB communications device class (or USB CDC) is a composite Universal Serial Bus device class. The communications device class is used for computer networking devices akin to a network card , providing an interface for transmitting Ethernet or ATM frames onto some physical media.
The Remote Network Driver Interface Specification (RNDIS) is a Microsoft proprietary protocol used mostly on top of USB. [1] It provides a virtual Ethernet link to most versions of the Windows, Linux, and FreeBSD operating systems. Multiple revisions of a partial RNDIS specification are available from Microsoft, but Windows implementations have ...
USB signals are transmitted using differential signaling on a twisted-pair data cable with 90 Ω ± 15% characteristic impedance. [6] Low speed (LS) and Full speed (FS) modes use a single data pair, labelled D+ and D−, in half-duplex. Transmitted signal levels are 0.0–0.3 V for logical low, and 2.8–3.6 V for logical high level.
The 24-pin double-sided connector provides four power–ground pairs, two differential pairs for USB 2.0 data (though only one pair is implemented in a USB-C cable), four pairs for SuperSpeed data bus (only two pairs are used in USB 3.1 mode), two "sideband use" pins, V CONN +5 V power for active cables, and a configuration pin for cable ...
USB 3.1 Gen 1 – newly marketed as SuperSpeed or SS, 5 Gbit/s signaling rate over 1 lane using 8b/10b encoding (raw data rate: 500 MB/s); replaces USB 3.0. USB 3.1 Gen 2 – new, marketed as SuperSpeed+ or SS+, 10 Gbit/s signaling rate over 1 lane using 128b/132b encoding (raw data rate: 1212 MB/s).
USB Attached SCSI (UAS) or USB Attached SCSI Protocol (UASP) is a computer protocol used to move data to and from USB storage devices such as hard drives (HDDs), solid-state drives (SSDs), and thumb drives. UAS depends on the USB protocol, and uses the standard SCSI command set.
Whereas earlier USB cables had a host end A and a peripheral device end B, a USB-C cable connects either way; and for interoperation with older equipment, there are cables with a Type-C plug at one end and either a Type-A (host) or a Type-B (peripheral device) plug at the other. The designation "C" refers only to the connector's physical ...
USB bridge cables, or data transfer cables can be found within the market, offering direct PC to PC connections. A bridge cable is a special cable with a chip and active electronics in the middle of the cable. The chip in the middle of the cable acts as a peripheral to both computers and allows for peer-to-peer communication between the computers.