Search results
Results from the WOW.Com Content Network
The maximum transmission distance is depending on the bit rate and the quality of the cable. RG-11, RG-6, RG-59, and other cable types can be used. It is also possible to reuse existing coaxial cable when upgrading from an analogue to a digital camera system. The original connector for CoaXPress is a 75 Ω IEC 61169-8 BNC connector.
Coaxial cable, or coax (pronounced / ˈ k oʊ. æ k s /), is a type of electrical cable consisting of an inner conductor surrounded by a concentric conducting shield, with the two separated by a dielectric (insulating material); many coaxial cables also have a protective outer sheath or jacket.
The first Ethernet standard, known as 10BASE5 (ThickNet) in the family of IEEE 802.3, specified baseband operation over 50 ohm coaxial cable, which remained the principal medium into the 1980s, when 10BASE2 (ThinNet) coax replaced it in deployments in the 1980s; both being replaced in the 1990s when thinner, cheaper twisted pair cabling came to dominate the market.
RG-59 coaxial cable is commonly packed with consumer equipment, such as VCRs or digital cable/satellite receivers. Manufacturers tend to include only RG-59 cables because it costs less than RG-6 does. However, given the short lengths provided (usually 4–6 ft or 1.2–1.8 m), this is generally sufficient for its typical use.
10BASE2 uses RG-58A/U cable or similar for a maximum segment length of 185 m as opposed to the thicker RG-8-like cable used in 10BASE5 networks with a maximum length of 500 m. The RG-58 type wire used by 10BASE2 was inexpensive, smaller and much more flexible than the specialized RG-8 variant. 10BASE2 can also use RG-59 cable.
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...
RG-58/U is a type of coaxial cable often used for low-power signal and RF connections. The cable has a characteristic impedance of either 50 or 52 Ω. "RG" was originally a unit indicator for bulk RF cable in the U.S. military's Joint Electronics Type Designation System. There are several versions covering the differences in core material ...
The technology was standardized in 1982 [1] as IEEE 802.3. 10BASE5 uses a thick and stiff coaxial cable [2] up to 500 meters (1,600 ft) in length. Up to 100 stations can be connected to the cable using vampire taps and share a single collision domain with 10 Mbit/s of bandwidth shared among them. The system is difficult to install and maintain.