Search results
Results from the WOW.Com Content Network
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
0.3048 m. 30.48 cm. 304.8 mm. The foot (standard symbol: ft) [1][2] is a unit of length in the British imperial and United States customary systems of measurement. The prime symbol, ′, is commonly used to represent the foot. [3] In both customary and imperial units, one foot comprises 12 inches, and one yard comprises three feet.
Parsecs are used in astronomy to measure interstellar distances. A parsec is approximately 3.26 light-years or about 3.086×10 16 m (1.917×10 13 mi). Combining it with the "atto-" prefix (×10 −18) yields attoparsec (apc), a conveniently human-scaled unit of about 3.086 centimetres (1.215 in) that is used only humorously.
An American football field, including both end zones, is 360 by 160 ft (120.0 by 53.3 yd; 109.7 by 48.8 m), or 57,600 square feet (5,350 m 2) (0.535 hectares or 1.32 acres). A Canadian football field is 65 yards (59 m) wide and 110 yards (100 m) long with end zones adding a combined 40 yards (37 m) to the length, making it 87,750 square feet ...
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...
The general relationship between absorbed dose and equivalent dose can be represented as. H = Q ⋅ D. where H is the equivalent dose, D is the absorbed dose, and Q is a dimensionless quality factor. Thus, for any quantity of D measured in Gy, the numerical value for H measured in Sv may be different.
An input unit can be converted to any number of output units—the outputs are specified as a "combination" by separating unit codes with a space (" ") or a plus (" + "). Using a space as a separator does not work if any of the unit codes contains a space. For example, each of the following converts 1.2 km 2 to acres, square yards, and hectares.
For petroleum gases, the standard cubic foot (scf) is defined as one cubic foot of gas at 60 °F (288.7 K; 15.56 °C) and at normal sea level air pressure. The pressure definition differs between sources, but are all close to normal sea level air pressure. A pressure of 14.696 pounds per square inch (1.00000 atm; 101.325 kPa). [2]