Search results
Results from the WOW.Com Content Network
The input digital signal may be over-the-air terrestrial television signals received by a television antenna, or signals from a digital cable system. It normally does not refer to satellite TV, which has always required a set-top box either to operate the big satellite dish, or to be the integrated receiver/decoder (IRD) in the case of direct ...
HDTV antenna amplifiers counteract poor picture and sound on local TV broadcasts caused by a degraded cable signal, which may occur when you use an extra-long run of cable or a line that runs ...
Belling-Lee connectors Flex Type F connectors. A TV aerial plug is a connector used to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal amplifiers, CATV distribution equipment, TV sets and FM / DAB-radio receivers.
That is, the antennas might both pick up the same station; the signal from the one with the shorter cable will reach the receiver slightly sooner, supplying the receiver with two pictures slightly offset. There may be phasing issues even with the same length of down-lead cable. Band-pass filters or signal traps may help to reduce this problem.
Older TV installations may use a solid dielectric RG-59 cable, and that cable may be inadequate. [1] RG-6 cable is typically used for satellite feed lines. In this application, there would be a diplexer on the roof that joins the satellite dish feed and the TV antenna together into a single coaxial cable. That cable would then run from the roof ...
In figure 21, an example is shown of a signal split up to feed multiple low power amplifiers, then recombined to feed a single antenna with high power. [52] Figure 21. Splitter and combiner networks used with amplifiers to produce a high power 40 dB (voltage gain 100) solid state amplifier Figure 22. Phase arrangement on a hybrid power combiner.
The system consists of a master antenna and a matching transformer to match the balanced antenna with unbalanced cable and amplifiers. [5] Most antennas have an impedance of around 300 Ω. To convert it to 75 Ω, a matching transformer (or balun) is used. For trunk line isolation, a resistive inductive device known as a splitter is used.
Coaxial cable brings the signal to the customer's building through a service drop, an overhead or underground cable. If the subscriber's building does not have a cable service drop, the cable company will install one. The standard cable used in the U.S. is RG-6, which has a 75 ohm impedance, and connects with a type F connector. The cable ...