enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Oil pump (internal combustion engine) - Wikipedia

   en.wikipedia.org/wiki/Oil_pump_(internal...

   Low oil pressure may be simply because there is not enough oil in the sump, due to burning oil (normally caused by piston ring wear or worn valve seals) or leakage. The piston rings serve to seal the combustion chamber, as well as remove oil from the internal walls of the cylinder.

3. Crankshaft deep rolling - Wikipedia

   en.wikipedia.org/wiki/Crankshaft_deep_rolling

   Deep rolling is a method of cold work deformation and burnishing of internal combustion engine crankshaft journal fillets to increase durability and design safety factors. Compressive residual stresses can be measured below the surface of a deep-rolled fillet. Other types of fillets on shafts or tubes can also benefit from this method.

4. Radial shaft seal - Wikipedia

   en.wikipedia.org/wiki/Radial_shaft_seal

   The line contact is formed by two angles, with the air side angle usually less than the oil side angle. Depending on the seal type these two angles are varied to create a pressure distribution at the seal contact line which has a steeper slope on the oil side of the seal. The shallower the slope on the oil side of the seal, the wetter the seal ...

5. Oil-filter wrench - Wikipedia

   en.wikipedia.org/wiki/Oil-filter_wrench

   Strap-type oil-filter wrench. A ratchet is used to turn it. Strap-type oil-filter wrench. This one has a handle built in. Socket-type oil-filter wrench. It fits over the end of the filter and is turned with a ratchet. It is made of stamped steel. An oil-filter wrench is a tool for removing spin-on type oil filters.

6. Crankshaft - Wikipedia

   en.wikipedia.org/wiki/Crankshaft

   Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942. The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3] The up-down motion of each piston is transferred to the crankshaft via connecting ...

7. Seal (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Seal_(mechanical)

   A seal is a device or material that helps join systems, mechanisms or other materials together by preventing leakage (e.g. in a pumping system), containing pressure, or excluding contamination. The effectiveness of a seal is dependent on adhesion in the case of sealants and compression in the case of gaskets .

8. Connecting rod - Wikipedia

   en.wikipedia.org/wiki/Connecting_rod

   A connecting rod, also called a 'con rod', [1] [2] [3] is the part of a piston engine which connects the piston to the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaft. [4] The connecting rod is required to transmit the compressive and tensile forces from ...

9. SeaTools - Wikipedia

   en.wikipedia.org/wiki/SeaTools

   Screenshot of SeaTools for Windows 1.4.0.2. It has detected three hard disk drives, one of them (the second) is a Seagate Technology model for which it is designed. Three tests have been run on disks. In order: S.M.A.R.T test, short self-test, short generic test.