Search results
Results from the WOW.Com Content Network
Thus, the outer diameter of a catheter in millimeters can be calculated by dividing the French size by 3. [2] For example, a catheter with a French size of 9 would have an outer diameter of approximately 3.07 mm. While the French scale aligns closely with the metric system, it introduces redundancy and the potential for rounding errors.
7.854 × 10 −7 square inches (1 square inch is about 1.273 million circular mils) 5.067 × 10 −10 square metres; 5.067 × 10 −4 square millimetres; 506.7 μm 2; 1000 circular mils = 1 MCM or 1 kcmil, and is (approximately) equal to: 0.5067 mm 2, so 2 kcmil ≈ 1 mm 2 (a 1.3% error)
The factor–label method can convert only unit quantities for which the units are in a linear relationship intersecting at 0 (ratio scale in Stevens's typology). Most conversions fit this paradigm. An example for which it cannot be used is the conversion between the Celsius scale and the Kelvin scale (or the Fahrenheit scale). Between degrees ...
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
The United States adopted the conversion factor 1 metre = 39.37 inches by an act in 1866. [30] In 1893, Mendenhall ordered the physical realization of the inch to be based on the international prototype metres numbers 21 and 27, which had been received from the CGPM, together with the previously adopted conversion factor. [31]
Countries using the metric system tend to use lines per centimeter (L/cm). In order to convert between L/in and L/cm the following formulas can be used: Lines per inch to lines per cm: L/cm = 0.394 x L/in i.e. 254 L/in = 100 L/cm Lines per cm to lines per inch: L/in = 2.54 x L/cm i.e. 100 L/cm = 254 L/in