Search results
Results from the WOW.Com Content Network
A fork end, [1] fork-end, [1] or forkend [2] is a slot in a bicycle frame or bicycle fork where the axle of a bicycle wheel is attached. A dropout is a type of fork end [3] that allows the rear wheel to be removed without first derailing the chain. Track bicycle frames have track fork ends, on which the opening faces rearwards. Because they do ...
Fork: a mechanical assembly that integrates a bicycle's frame to its front wheel and handlebars, allowing steering by virtue of its steerer tube; Fork crown: the point at which the two blades of the fork meet below the steerer tube. Fork end: paired slots on a fork or frame at
Diameters for front thru axles include 20 mm, 15 mm, 12 mm, and 9 mm. Rear axles typically have diameters of 10 or 12 mm. Most thru axles are found on mountain bikes, although increasingly disc-braked cyclocross and road bikes are using them. Thru axles repeatably locate the wheel in the fork or frame, which is important to prevent misalignment ...
The length of the fork is usually measured parallel to the steerer tube from the bottom of the lower bearing race to the center of the front wheel axle. [3] A 1996 survey of 13 700c road forks found a maximum length of 374.7 mm and a minimum of 363.5 mm. [citation needed]
The axle receives its vertical and transverse support from a transverse leaf spring (leaf springs were often used for support in more than one direction), and its longitudinal support from fore-aft links sometimes called "radius rods" which are attached (via pivots) to the ends of the axle at their forward end and to the sides of the chassis ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
RMR layout; the engine is located in front of the rear axle. Rear Mid-engine transversely-mounted / Rear-wheel drive. In automotive design, an RMR, or rear mid-engine, rear-wheel-drive layout is one in which the rear wheels are driven by an engine placed with its center of gravity in front of the rear axle, and thus right behind the passenger compartment.