enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Strut channel - Wikipedia

    en.wikipedia.org/wiki/Strut_channel

    A deep channel 1 + 5 ⁄ 8 in × 2 + 7 ⁄ 16 in (41 mm × 62 mm) version is also manufactured. The material used to form the channel is typically sheet metal with a thickness of 1.5 mm or 2.5 mm (12 or 14 gauge; 0.1046 inch or 0.0747 inch, respectively). [2] Types of channel

  3. T-slot structural framing - Wikipedia

    en.wikipedia.org/wiki/T-slot_structural_framing

    It is also known under several generic names, such as aluminium extrusion, aluminium profile and 2020 extrusion if the cross-section is 20x20 mm, alongside brand names, such as 80/20 framing. [ 1 ]

  4. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  5. Hydraulic diameter - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_diameter

    For the limiting case of a very wide duct, i.e. a slot of width b, where b ≫ a, then D H = 2a. Channel of water or partially filled rectangular duct. Open from top by definition so that the wetted perimeter consists of the 3 sides of the duct (2 on the side and the base).

  6. Rack unit - Wikipedia

    en.wikipedia.org/wiki/Rack_unit

    Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...

  7. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  8. Rolling (metalworking) - Wikipedia

    en.wikipedia.org/wiki/Rolling_(metalworking)

    Billet mills, three-high, rolls from 24 to 32 inches in diameter, used for the further reduction of blooms down to 1.5x1.5-inch billets, being the nubpreparatory mills for the bar and rod Beam mills, three-high, rolls from 28 to 36 inches in diameter, for the production of heavy beams and channels 12 inches and over.

  9. Sheet metal - Wikipedia

    en.wikipedia.org/wiki/Sheet_metal

    Cutting speeds on thin 1.2 mm (0.047 in) sheet can be as high as 25 m (82 ft) per minute. Most laser cutting systems use a CO 2 based laser source with a wavelength of around 10 μm ; some more recent systems use a YAG based laser with a wavelength of around 1 μm.