Search results
Results from the WOW.Com Content Network
Quick connect fittings are intended to be applied more easily than traditional fittings, requiring only that the pipes be pushed together firmly to lock the teeth of the fitting firmly. The teeth are forced deeper into the tubing when opposing force is applied to them, preventing their separation from the tubing.
A push-in compression coupling and tee.. Push-to-pull, push-to-connect, push-in, push-fit, or instant fittings are a type of easily removed compression fitting or quick connect fitting that allows an air (or water) line to be attached, nominally without the use of tools (a tool is still usually required for cutting tubing to length and removal).
A tube-shaped connector with two crimps for splicing wires in-line is called a butt splice connector. Single-wire crimp terminals include: Blade or quick disconnect (e.g., Faston or Lucar) Bullet (e.g. Shur-Plug) Butt splice; Flag tongue; Rectangular tongue; Hook tongue; Spade tongue (flanged, short spring, long spring) Ring tongue (slotted ...
FASTON terminals or faston terminals are connectors that are widely used in electronic and electrical equipment. These terminals are manufactured by many companies, commonly using the terms "quick disconnect", "quick connect", "tab" terminals, "spade" terminals [ 1 ] or blade connectors ; without qualifiers, the first two could be mistaken for ...
Crimped connectors are a type of solderless connection, using mechanical friction and uniform deformation to secure a connector to a pre-stripped wire (usually stranded). [1] Crimping is used in splice connectors, crimped multipin plugs and sockets, and crimped coaxial connectors. Crimping usually requires a specialised crimping tool, but the ...
When such a connector is twisted onto the stripped ends of wires, the wires are drawn into the connector's metal insert and squeezed together inside it. Electrical continuity is maintained both by the direct twisted wire-to-wire contact and by contact with the metal insert. Twist-on wire connectors are typically installed by hand.
Subsequently, the fibers are fused together (welded) with an electric arc. Since no additional material is added, such as gas welding or soldering, this is called a "fusion splice". Depending on the quality of the splicing process, attenuation values at the splice points are achieved by 0.3 dB, with good splices also below 0.02 dB.
The push–pull connector is a type of cable interconnect that provides a strong locking mechanism that is only released by squeezing the connector body, thus preventing accidental disconnects. The connector is cylindrical, enabling a wide range of body styles and configurations such as low or high voltage multipin, coaxial, triaxial, fluid and ...