Search results
Results from the WOW.Com Content Network
A chalkboard eraser (sometimes known as a duster in India and elsewhere [1] [2]) is a special type of eraser specifically used to erase chalk markings on slating paint (used on chalkboards and slates). It is most commonly made of felt strips attached to a handle. Chalkboard erasers are typically broad and rectangular, intended to clear large ...
Chalk writing leaves light-colored particles weakly adhering to a dark surface (e.g., white on black, or yellow on green); it can be rubbed off with a soft material, such as a rag. Erasers for chalkboards are made, with a block of plastic or wood, much larger than an eraser for pen or pencil, with a layer of felt on one side.
Wet wipe markers were often used on overhead projector transparencies, as they could be stored and transported easily, unlike a traditional chalkboard. With the rise of computerized slide-shows (e.g. PowerPoint) in the classroom and office, overhead usage has reduced substantially, and with it, the wet wipe marker. Marks can then be cleaned off ...
A chalkboard with an eraser in the chalk tray. A blackboard can simply be a board painted with a dark matte paint (usually black, occasionally dark green). [1] Matte black plastic sign material (known as closed-cell PVC foamboard) is also used to create custom chalkboard art. [2]
A whiteboard (also known by marker board, dry-erase board, dry-wipe board, and pen-board) is a glossy, usually white surface for making non-permanent markings. Whiteboards are analogous to blackboards , but with a smoother surface allowing for rapid marking and erasing of markings on their surface.
Another type of paint marker is the solidified paint pen. This is a type of marker, often contained within a twist tube, that is a cylinder of semi-hardened oil-paint with a pointed tip. As one writes with it, the point wears down and must be advanced to in order to continue writing. The marker leaves a mark similar to that of chalk. It is ...
In concert with bladed ink erasers, an eraser similar to those at the end of pencils was also used, with additional abrasives, such as sand, mixed into the rubber. Fibreglass ink erasers also work by abrasion. These erasers physically remove the ink and the paper it has marked from the larger sheet.
Interior and exterior surfaces including metal, wood, glass, concrete, plaster, and fabric, may be painted with chalk paint. [3] Chalk paint may be applied with a brush, roller, or spray gun. [5] The paint should be applied in thin layers and will typically dry within two hours. [3] A topcoat sealer, such as wax or lacquer, should be applied to ...