Search results
Results from the WOW.Com Content Network
This same notation is used in both UTM and MGRS, i.e. the UTM grid reference system; the article on Universal Transverse Mercator shows many maps of these grid zones, including the irregularities for Svalbard and southwest Norway. As Figure 1 illustrates, Honolulu is in grid zone 4Q. Figure 1. The origin of the MGRS grid, in the Pacific.
Like the UTM coordinate system, the UPS coordinate system uses a metric-based cartesian grid laid out on a conformally projected surface. UPS covers the Earth's polar regions, specifically the areas north of 84°N and south of 80°S, which are not covered by the UTM grids, plus an additional 30 minutes of latitude extending into UTM grid to ...
The Universal Transverse Mercator (UTM) is a map projection system for assigning coordinates to locations on the surface of the Earth.Like the traditional method of latitude and longitude, it is a horizontal position representation, which means it ignores altitude and treats the earth surface as a perfect ellipsoid.
[20] [21] The six-degree zone width of UTM strikes a balance between the frequency of these discontinuities versus distortion of scale, which would increase unacceptably if the zones were made wider. (UTM further uses a 0.9996 scale factor at the central meridian, growing to 1.0000 at two meridians offset from the center, and increasing toward ...
The difference between the latest as of 2006 WGS 84 (frame realisation G1150) and the latest ITRF2000 is only a few centimeters and RMS difference of one centimeter per component. [1] The ITRS and ITRF solutions are maintained by the International Earth Rotation and Reference Systems Service . Practical navigation systems are in general ...
Geodetic Reference System 1980: ISO 6709: Geographic point coord. 1983: NAD 83: North American Datum 1983: WGS 84: World Geodetic System 1984: NAVD 88: N. American Vertical Datum 1988: ETRS89: European Terrestrial Ref. Sys. 1989: GCJ-02: Chinese obfuscated datum 2002: Geo URI: Internet link to a point 2010
ITM is based on the Universal Transverse Mercator coordinate system (UTM), used to provide grid references for worldwide locations, and this is the system commonly used for the Channel Islands. European-wide agencies also use UTM when mapping locations, or may use the Military Grid Reference System (MGRS), or variants of it.
For example, in the Military Grid Reference System, the above coordinate is in grid 11U (representing UTM Zone 11 5xxxxxx mN), and grid cell NS within that (representing the second digit 5xxxxxmE x6xxxxxm N), and as many remaining digits as are needed are reported, yielding an MGRS grid reference of 11U NS 949 361 (or 11U NS 9493 3617 or 11U NS ...