enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   35-pin MicroCross Molex connector VESA Enhanced Video Connector and VESA Plug and Display (a.k.a. M1-DA) both used this connector with slightly different pin assignments. These schemes combined VGA or digital video, audio, FireWire, and USB signals into a single connector.

3. 16-pin 12VHPWR connector - Wikipedia

   en.wikipedia.org/wiki/16-Pin_12vHPWR_connector

   The connector first appeared in the Nvidia RTX 40 GPUs. [5] [6] The prior Nvidia RTX 30 series introduced a similar, proprietary connector in the "Founder's Edition" cards, which also uses an arrangement of twelve pins for power, but did not have the sense pins, except for the connector on the founders edition RTX 3090 Ti (though not present on the adapter supplied with those cards.) [7]

4. VGA connector - Wikipedia

   en.wikipedia.org/wiki/VGA_connector

   In the male connector, this pin numbering corresponds with the cable's wire-and-solder side. The Video Graphics Array ( VGA ) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [ 1 ] as well as many monitors ...

5. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   The ATX connector provides multiple wires and power connections for the 3.3 V supply, because it is most sensitive to voltage drop in the supply connections. Another ATX addition was the +5 V SB (standby) rail for providing a small amount of standby power , even when the computer was nominally "off".

6. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   Black, Red and Blue are used for hot wires and White is used as the neutral wire in a 120/208 V circuit. Brown, Orange and Yellow are used as hot wires and gray is used as the neutral wire in a 277/480 V. For grounding, regardless of the voltage, Green (or a bare wire) is used.

7. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.