Search results
Results from the WOW.Com Content Network
A tailstock, also known as a foot stock, [1] is a device often used as part of an engineering lathe, wood-turning lathe, or used in conjunction with a rotary table on a milling machine. It is usually used to apply support to the longitudinal rotary axis of a workpiece being machined.
Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis.
A tool is inserted into the chuck, and is locked in place until the lock is released. The rotary force is transmitted through wedges that fit into two or three open grooves. The bit is free to move a short distance and the hammer action moves the bit up and down within the chuck.
An indexing head, also known as a dividing head or spiral head, [1] is a specialized tool that allows a workpiece to be circularly indexed; that is, easily and precisely rotated to preset angles or circular divisions.
In this configuration a tailstock can also be used, thus holding the workpiece "between centers." With the table mounted on a secondary table, the workpiece is accurately centered on the rotary table's axis, which in turn is centered on the cutting tool's axis. All three axes are thus coaxial. From this point, the secondary table can be offset ...
For spindle turning, the wood is held on the lathe either by both ends (between the headstock and tailstock) or by one end only using a lathe chuck [2]. Wood is generally removed by running a turning tool down the slope of the wood from a larger diameter in the wood to a smaller diameter.
The wood rotates between the headstock of the lathe which includes the drive mechanism and the tailstock support, which only rotates if its center is 'live' or supported by a rotating holding device. The headstock end may use points or spurs which are driven into the wood. This type of turning is described as 'between centers.'
In many lathe tailstocks, the tool is removed by fully withdrawing the quill into the tailstock, which brings the tool up against the end of the leadscrew or an internal stud, separating the taper and releasing the tool. Where the tool is retained by a drawbar, as in some mill spindles, the drawbar is partially unthreaded with a wrench and then ...