Search results
Results from the WOW.Com Content Network
ASTM A325. ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from ⁄ to 1⁄ inches (13 to 38 mm) in diameter. [1]
ISO 898. ISO 898 is an international standard that defines mechanical and physical properties for metric fasteners. This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts:
This standard defines property classes, the metric equivalent of a screw grade, that are almost identical to those defined by ISO 898-1, [2] except for the addition of the 8.8.3 and 10.9.3 classes. These two additional standards are fasteners that have the same mechanical properties as their base property class (i.e. 8.8 and 10.9), but are made ...
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
Ford released an updated version in both solid and IRS form for 2015+ Mustangs and F-150. The most apparent difference is a 12 bolt cover instead of the traditional 10. The super 8.8 also uses larger bearings,longer pinion with larger nut, and most significantly 34 spline axles or half shafts.
The torque applied to the fastener must be determined such that it does not contribute to a service condition where the fastener enters a low-cycle fatigue regime. In general, the use of torque-to-yield fasteners is deprecated except in cases where the materials and structures comprising the entire assembly are certified to be within tolerances ...
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...
The Cummins M-series engine is a straight-six diesel engine designed and produced by Cummins.It displaces 10.8 litres (659.1 cu in).Introduced as the M11 in 1994, it was built on the previous L10 engine (same 4.921 inches (125.0 mm) cylinder bore, but a longer 5.787 inches (147.0 mm) piston stroke compared to the L10's 5.354 inches (136.0 mm) stroke).