enow.com Web Search

  1. Ads

    related to: parts of laboratory water bath heater circulator pump

Search results

  1. Results from the WOW.Com Content Network
  2. Thermal immersion circulator - Wikipedia

    en.wikipedia.org/wiki/Thermal_immersion_circulator

    A thermal immersion circulator comprises a circulator pump or motorized impeller to move the fluid, a heating element immersed in the fluid, an accurate temperature probe, and control circuitry which compares the measured temperature with the desired value and supplies power to the heater as required to stabilize the temperature.

  3. Circulator pump - Wikipedia

    en.wikipedia.org/wiki/Circulator_pump

    This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...

  4. Laboratory water bath - Wikipedia

    en.wikipedia.org/wiki/Laboratory_water_bath

    A water bath is laboratory equipment made from a container filled with heated water. It is used to incubate samples in water at a constant temperature over a long period of time. Most water baths have a digital or an analogue interface to allow users to set a desired temperature, but some water baths have their temperature controlled by a ...

  5. Heated bath - Wikipedia

    en.wikipedia.org/wiki/Heated_bath

    Heated bath schema. 1: Heated substance. 2: Heating medium. 3: Laboratory flask. 4: Bowl. 5: Gas burner. A heated bath is used in the laboratory to allow a chemical reaction to occur at an elevated temperature. [1] In contrast to traditional Bunsen burners, heated baths use liquids to transfer heat to the reaction vessel. This is achieved using ...

  6. Reflux - Wikipedia

    en.wikipedia.org/wiki/Reflux

    The diagram shows a typical reflux apparatus. It includes a water bath to indirectly heat the mixture. As many solvents used are flammable, direct heating with a Bunsen burner is not generally suitable, and alternatives such as a water bath, oil bath, sand bath, electric hot plate or heating mantle are employed. [6]

  7. Circulation evaporator - Wikipedia

    en.wikipedia.org/wiki/Circulation_evaporator

    The evaporator uses separate parts to create the overall system; a heat exchanger, separation tank and for the forced circulation system (as opposed to the natural circulation system) a circulation pump are standard although can be subject to change depending on the liquids properties of the mixtures being separated and specific design.

  1. Ads

    related to: parts of laboratory water bath heater circulator pump