Search results
Results from the WOW.Com Content Network
The collective pitch control, or collective lever, is normally located on the left side of the pilot's seat with an adjustable friction control to prevent inadvertent movement. The collective changes the pitch angle of all the main rotor blades collectively (i.e., all at the same time) and is independent of their position in the rotational cycle.
Cyclic/collective pitch mixing (CCPM) is a control concept employed in collective pitch radio-controlled helicopters. [1] CCPM reduces mechanical complexity and increases precision of control of the helicopter rotor's swashplate. Unlike conventional systems in which a single actuator is responsible for a single axis, CCPM mechanisms allow ...
Such models are usually fixed-pitch (i.e., the blades cannot be rotated on their axes for different angles of attack), simplifying the model but eliminating the ability to compensate with collective input. Compensating for even the slightest breeze causes the model to climb rather than to fly forward even with full application of cyclic.
This hinge is responsible for the change in pitch of rotor blades excited via pilot input to the collective or cyclic. A variation of the fully articulated system is the soft-in-plane rotor system. This type of rotor can be found on several aircraft produced by Bell Helicopter, such as the OH-58D Kiowa Warrior .
In the case of pitch, the entire swashplate is moved along the mainshaft by a one actuator. However, some newer model helicopters remove this mechanically complex separation of functionalities by using three interdependent actuators that can each move the entire swashplate. This is called cyclic/collective pitch mixing (CCPM). The benefit of ...
If the pilot pushes the cyclic to the side, the rotor disk tilts to that side and produces thrust in that direction, causing the helicopter to hover sideways. [citation needed] The collective pitch control or collective is located on the left side of the pilot's seat with a settable friction control to prevent inadvertent movement. The ...
Learning to fly a collective pitch RC helicopter takes time and practice. Many modelers join a club so they can be instructed by experienced RC pilots, or follow on-line guides. [12] RC Helicopters usually have at least four controls: roll - cyclic pitch, elevator (fore-aft cyclic pitch), rudder (yaw) and pitch/throttle (collective pitch/power ...
Pitch is provided through rotor blades cyclic-, or nacelle, tilt. Vertical motion is controlled with conventional rotor blade pitch and either a conventional helicopter collective control lever (as in the Bell/Agusta BA609 ) or a unique control similar to a fixed-wing engine control called a thrust control lever (TCL) (as in the Bell-Boeing V ...