Search results
Results from the WOW.Com Content Network
The intermodulation between frequency components will form additional components at frequencies that are not just at harmonic frequencies (integer multiples) of either, like harmonic distortion, but also at the sum and difference frequencies of the original frequencies and at sums and differences of multiples of those frequencies.
SASERs could have wide applications. Apart from facilitating the investigation of terahertz-frequency ultrasound, the SASER is also likely to find uses in optoelectronics (electronic devices that detect and control light—as a method of transmitting a signal from an end to the other of, for instance, fiber optics), as a method of signal modulation and/or transmission.
If the frequency deviation is held constant and the modulation frequency increased, the spacing between spectra increases. Frequency modulation can be classified as narrowband if the change in the carrier frequency is about the same as the signal frequency, or as wideband if the change in the carrier frequency is much higher (modulation index ...
The frequency range handled by an amplifier might be specified in terms of bandwidth (normally implying a response that is 3 dB down when the frequency reaches the specified bandwidth), or by specifying a frequency response that is within a certain number of decibels between a lower and an upper frequency (e.g. "20 Hz to 20 kHz plus or minus 1 ...
The EI-EPR spectra can be collected in two ways: (1) difference spectra [7] (2) frequency modulated rf field without Zeeman modulation. This technique was established by Hyde [ 7 ] and is especially useful for separating overlapping EPR signals which result from different radicals, molecular conformations or magnetic sites.
Amplifies the difference in voltage between its inputs. The name "differential amplifier" must not be confused with the " differentiator ", which is also shown on this page. The " instrumentation amplifier ", which is also shown on this page, is a modification of the differential amplifier that also provides high input impedance .
The frequency response for a conventional LP player might be 20 Hz to 20 kHz, ±3 dB. The low-frequency response of vinyl records is restricted by rumble noise (described above), as well as the physical and electrical characteristics of the entire pickup arm and transducer assembly. The high-frequency response of vinyl depends on the cartridge.
The period (symbol T) is the interval of time between events, so the period is the reciprocal of the frequency: T = 1/f. [2] Frequency is an important parameter used in science and engineering to specify the rate of oscillatory and vibratory phenomena, such as mechanical vibrations, audio signals , radio waves, and light.