Search results
Results from the WOW.Com Content Network
128-byte buffers. This UART can handle a maximum standard serial port speed of 921.6 kbit/s if the maximum interrupt latency is 1 millisecond. This UART supports 9-bit characters in addition to the 5- to 8-bit characters that other UARTs support. This was introduced by Oxford Semiconductor, which is now owned by PLX Technology.
The USART's synchronous capabilities were primarily intended to support synchronous protocols like IBM's synchronous transmit-receive (STR), binary synchronous communications (BSC), synchronous data link control (SDLC), and the ISO-standard high-level data link control (HDLC) synchronous link-layer protocols, which were used with synchronous voice-frequency modems.
The 16550 UART (universal asynchronous receiver-transmitter) is an integrated circuit designed for implementing the interface for serial communications. The corrected -A version was released in 1987 by National Semiconductor . [ 1 ]
UARTs that lack such support, like the 16550, may suffer from buffer overruns when using software flow control, although this can be somewhat mitigated by disabling the UART's FIFO. [1] Finally, since the XOFF/XON codes are sent in-band, they cannot appear in the data being transmitted without being mistaken for flow control commands.
Asynchronous start-stop is the lower data-link layer used to connect computers to modems for many dial-up Internet access applications, using a second (encapsulating) data link framing protocol such as PPP to create packets made up out of asynchronous serial characters. The most common physical layer interface used is RS-232D.
In computer engineering and electrical engineering, bit banging [1] or bit bashing [citation needed] is a term of art for any method of data transmission that employs software as a substitute for dedicated hardware to generate transmitted signals or process received signals.
The original Verilog simulator, Gateway Design's Verilog-XL was the first (and only, for a time) Verilog simulator to be qualified for ASIC (validation) sign-off. After its acquisition by Cadence Design Systems, Verilog-XL changed very little over the years, retaining an interpreted language engine, and freezing language-support at Verilog-1995.
The pseudocode below outlines a software implementation ("bit-banging") of SPI's protocol as a main with simultaneous output and input. This pseudocode is for CPHA=0 and CPOL=0, thus SCLK is pulled low before CS is activated and bits are inputted on SCLK's rising edge while bits are outputted on SCLK's falling edge.