Search results
Results from the WOW.Com Content Network
Sleep mode (or suspend to RAM) is a low power mode for electronic devices such as computers, televisions, and remote controlled devices. These modes save significantly on electrical consumption compared to leaving a device fully on and, upon resume, allow the user to avoid having to reissue instructions or to wait for a machine to boot .
A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on. [ 1 ] POST processes may set the initial state of the device from firmware and detect if any hardware components are non-functional.
Likewise, Linux distributions include a variety of power management settings and tools. [5] There is a significant market in third-party PC power management software offering features beyond those present in the Windows operating system. [6] [7] [8] Notable vendors Data Synergy's 'PowerMAN', [9] Faronics' 'Power Save', [10] [11] and Verdiem's ...
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring. It was first released in ...
Standby power, also called vampire power [1], vampire draw, phantom load, ghost load, or leaking electricity, refers to how electronic and electrical appliances consume electric power. At the same time, they are switched off (but are designed to draw some power) or in standby mode. It only occurs because some devices claim to be "switched off ...
Windows Vista introduced a hybrid sleep feature, which saves the contents of memory to hard disk but instead of powering down, enters sleep mode. If the power is lost, the computer can resume as if hibernated. Windows 7 introduced compression to the hibernation file and set the default size to 75% of the total physical memory. [18]
The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).
Original IBM power supplies for the PC (model 5150), XT and AT included a line-voltage power switch that extended through the side of the computer case. In a common variant found in tower cases, the line-voltage switch was connected to the power supply with a short cable, allowing it to be mounted apart from the power supply.