enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

3. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...

4. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   Countersink cutters are manufactured with six common angles, which are 60°, 82°, 90°, 100°, 110°, or 120°, with the two most common of those being 82° and 90°. Countersunk-head screws that follow the Unified Thread Standard very often have an 82° angle, and screws that follow the ISO standard very often have a 90° angle. Throughout ...

5. Molly (fastener) - Wikipedia

   en.wikipedia.org/wiki/Molly_(fastener)

   A machine screw is screwed into the sleeve, causing the anchor to bend, expand, spread and grip against the inside of the hole or behind it (in hollow contexts such as drywall over stud cavities, or hollow doors). [1] Mollies come in various diameters and grip lengths (shank lengths) for different drywall thicknesses and to support different ...

6. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A lathe of 1871, equipped with leadscrew and change gears for single-point screw-cutting A Brown & Sharpe single-spindle screw machine. Fasteners had become widespread involving concepts such as dowels and pins, wedging, mortises and tenons, dovetails, nailing (with or without clenching the nail ends), forge welding, and many kinds of binding with cord made of leather or fiber, using many ...

7. Pipe support - Wikipedia

   en.wikipedia.org/wiki/Pipe_support

   A pipe anchor is a rigid support that restricts movement in all three orthogonal directions and all three rotational directions, i.e. restricting al the 6 degrees of freedom This usually is a welded stanchion that is welded or bolted to steel or concrete. [2] In case of anchor which is bolted to concrete, a special type of bolt is required ...

8. Screw piles - Wikipedia

   en.wikipedia.org/wiki/Screw_piles

   Large load capacity screw piles may have various components such as flat half helices, Bisalloy cutting tips and helices, cap plates or rebar interfaces for connection to various concrete or steel structures. Most industries use screw piling experts due to the cost efficiencies and, increasingly, the reduced environmental impact.

9. Precast concrete lifting anchor system - Wikipedia

   en.wikipedia.org/wiki/Precast_concrete_lifting...

   The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...