Search results
Results from the WOW.Com Content Network
A coupling or coupler is a mechanism, typically located at each end of a rail vehicle, that connects them together to form a train. The equipment that connects the couplers to the vehicles is the draft gear or draw gear, which must absorb the stresses of the coupling and the acceleration of the train.
The diagram from Beard's 1897 coupler patent [1]. Janney couplers were first patented in 1873 by Eli H. Janney (U.S. patent 138,405). [2] [3] Andrew Jackson Beard was amongst various inventors that made a multitude of improvements to the knuckle coupler; [1] Beard's patents were U.S. patent 594,059 granted 23 November 1897, which then sold for approximately $50,000, and U.S. patent 624,901 ...
Narrow gauge flat wagons, 750 mm (2 ft 5 + 1 ⁄ 2 in).Note the single buffer with a hook on the right side and a chain on the other. On some narrow-gauge lines in Europe, and on the Paris Metro, a simplified version of the loose-coupler is used, consisting of a single central buffer with a chain underneath.
The railcar couplers or couplings listed, described, and depicted below are used worldwide on legacy and modern railways. Compatible and similar designs are frequently referred to using widely differing make, brand, regional or nick names, which can make describing standard or typical designs confusing.
On a standard-gauge railway, the nominal mounting height for the coupler (rail top to coupler center) is 33 inches (838 mm), with a 34 + 1 ⁄ 2 ± 1 inch (876 ± 25 mm) maximum height on empty cars and 31 + 1 ⁄ 2 ± 1 inch (800 ± 25 mm) minimum height on loaded cars.
A pneumatic buffer with sections cut away. A buffer is a part of the buffers and chain coupler system used on the railway systems of many countries, among them most of those in Europe, for attaching railway vehicles together (in North America, rolling stock instead has draft gear built into the couplers).
An axlebox, also known as a journal box in North America, is the mechanical subassembly on each end of the axles under a railway wagon, coach or locomotive; it contains bearings and thus transfers the wagon, coach or locomotive weight to the wheels and rails; the bearing design is typically oil-bathed plain bearings on older rolling stock, or roller bearings on newer rolling stock.
Different types of railroad rolling stock have different couplers depending on the purpose and type of equipment being used and its intended destination. European rolling stock tend to use buffers and chain couplers while American rolling stock uses a Janney coupler or "knuckle coupler". These are incompatible with each other, but where some ...