Search results
Results from the WOW.Com Content Network
This type of on-hook/off-hook supervision was in use in step-by-step systems as well as electronic switching systems in North America for many decades. [ 2 ] Disconnect supervision signals the called terminal device, typically an automated customer premises equipment, that the remote calling party has hung up. [ 3 ]
If a battery has been completely discharged (e.g. the car lights were left on overnight) and next is given a fast charge for only a few minutes, then during the short charging time it develops only a charge near the interface. The battery voltage may rise to be close to the charger voltage so that the charging current decreases significantly.
General Motors, and other automobile manufacturers, have also begun using side-post battery terminals, which consist of two recessed female 3/8" threads (SAE 3/8-16) into which bolts or various battery terminal adapters are to be attached. These side posts are of the same size and do not prevent incorrect polarity connections.
In stand-alone photovoltaic power systems, the electrical energy produced by the photovoltaic panels cannot always be used directly. As the demand from the load does not always equal the solar panel capacity, battery banks are generally used. The primary functions of a storage battery in a stand-alone PV system are:
In general, a checklist is a quality management tool, an aid to completing a complex task correctly and completely. It is an aid to recall, provides a reminder of the correct sequence, and uses the operator's knowledge and skill efficiently to ensure that no critical steps are omitted, even when the operator is under stress or has degraded attention due to fatigue or other distractions, It ...
Battery types such as the 9-volt have snap-on contacts. Battery holders for zinc-air batteries must not be completely air-tight since approximately 1 litre of air is required per ampere-hour of discharge per cell. The battery holder may include a valve integrated with the device power switch to allow air to be admitted when the device is ...
This is the typical procedure in most North American networks and some office systems: Pick up phone handset (causing the line to be off-hook). Hear a dial tone. Dial the first number and greet the first party. Press the hook flash button (or quickly tap the on-hook sensor on the phone).
In very early vacuum tube television sets, the EHT was derived directly from a high voltage winding on the mains transformer using a half wave rectifier.In later television sets, the EHT supply was invariably generated by rectifying the flyback pulses from the scanning circuitry rather than directly from the mains supply (a practice that survived the transition to transistor circuits).