Search results
Results from the WOW.Com Content Network
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
The DVCAM SDTI has video data at the top, control data in the middle (Timecode, etc.) and audio at the bottom just like it is organised on the tape. Because SDTI is used for compressed data the area used is less than a full screen; this allows for faster than realtime transfers.
SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...
Two video matrix units in a rack. A video router, also known as a video matrix switch or SDI router, is an electronic switch designed to route video signals from multiple input sources such as cameras, VT/DDR, computers and DVD players, to one or more display devices, such as monitors, projectors, and TVs.
Among the targeted use cases are video transport over professional video links (like SDI and professional video over IP), real-time video storage, memory buffers, omnidirectional video capture and rendering, and image sensor compression (for example in cameras and in the automotive industry). [10]
A Transport Stream, and thereby ASI when over coax, can carry one or multiple SD, HD or audio programs that are already compressed, as opposed to an uncompressed SD-SDI (270 Mbit/s) or HD-SDI (1.485 Gbit/s). An ASI signal can be at varying transmission speeds and is completely dependent on the user's engineering requirements.
Level A format is the direct mapping of uncompressed 1080p (up to 60 fps) video into a serial digital interface at the nominal 3 Gbit/s. That is, one video signal, one video stream, in one cable. Level B-DL format is the mapping of dual-link HD-SDI/ SMPTE 372M (i.e.: 1080p up to 60 fps) in a single serial digital interface at the nominal 3 Gbit/s.
Microsoft provides a tool called the "SDI File Manager" (sdimgr.exe) which can be used for the purpose of manipulating SDI files. Some of the tasks which this tool facilitates are: The creation of an SDI image file. The creation of an SDI image file from an existing hard disk partition. The verification of an existing SDI image.