Search results
Results from the WOW.Com Content Network
The message body that follows is by default an XML message and can contain a number of separate response codes, depending on how many sub-requests were made. [7] 208 Already Reported (WebDAV; RFC 5842) The members of a DAV binding have already been enumerated in a preceding part of the (multistatus) response, and are not being included again.
The message in the box is hidden from the receiver, who cannot open the lock themselves. Since the receiver has the box, the message inside cannot be changed—merely revealed if the sender chooses to give them the key at some later time. Interactions in a commitment scheme take place in two phases:
This is a list of Simple Mail Transfer Protocol (SMTP) response status codes. Status codes are issued by a server in response to a client's request made to the server. Unless otherwise stated, all status codes described here is part of the current SMTP standard, RFC 5321. The message phrases shown are typical, but any human-readable alternative ...
In coding theory, the repetition code is one of the most basic linear error-correcting codes. In order to transmit a message over a noisy channel that may corrupt the transmission in a few places, the idea of the repetition code is to just repeat the message several times. The hope is that the channel corrupts only a minority of these repetitions.
A specified period of time that will be allowed to elapse in a system before a specified event is to take place, unless another specified event occurs first; in either case, the period is terminated when either event takes place. Note: A timeout condition can be canceled by the receipt of an appropriate time-out cancellation signal.
Note that Alice cannot encode her telephone number in just one err-mail, because it contains six characters, and that the maximum length of one err-mail message is five characters. If she sent her phone number in pieces, asking Bob to acknowledge receipt of each piece, at least four messages would have to be sent anyway (two from Alice, and two ...
Linear block codes are frequently denoted as [n, k, d] codes, where d refers to the code's minimum Hamming distance between any two code words. (The [ n , k , d ] notation should not be confused with the ( n , M , d ) notation used to denote a non-linear code of length n , size M (i.e., having M code words), and minimum Hamming distance d .)
Magic numbers become particularly confusing when the same number is used for different purposes in one section of code. It is easier to alter the value of the number, as it is not duplicated. Changing the value of a magic number is error-prone, because the same value is often used several times in different places within a program. [6]