Search results
Results from the WOW.Com Content Network
The Reactor Protection System (RPS) is a system, computerized in later BWR models, that is designed to automatically, rapidly, and completely shut down and make safe the Nuclear Steam Supply System (NSSS – the reactor pressure vessel, pumps, and water/steam piping within the containment) if some event occurs that could result in the reactor entering an unsafe operating condition.
The Delco ignition system, also known as the Kettering ignition system, points and condenser ignition or breaker point ignition, is a type of inductive discharge ignition system invented by Charles F. Kettering. It was first sold commercially on the 1912 Cadillac [1] and was manufactured by Delco.
The causes of the accident on 25 September 1998 amounted to a failure to provide and maintain so far as practicable a working environment that was safe and without risks to health. This constituted a breach or breaches of section 21 of the [Victorian] Occupational Health and Safety Act 1985. [26]
Discovering that patient safety had become a frequent topic for journalists, health care experts, and the public, it was harder to see overall improvements on a national level. What was noteworthy was the impact on attitudes and organizations. Few health care professionals now doubted that preventable medical injuries were a serious problem.
Articles relating to ignition systems, which generate a spark or heat an electrode to a high temperature to ignite a fuel-air mixture. Subcategories This category has only the following subcategory.
Risks of this sort are usually managed with the methods and tools of safety engineering. A safety-critical system is designed to lose less than one life per billion (10 9) hours of operation. [7] [8] Typical design methods include probabilistic risk assessment, a method that combines failure mode and effects analysis (FMEA) with fault tree ...
Once the lower explosive limit (LEL) is reached, any source of ignition will cause an explosion of the vapors. A fuel explosion within the confines of the firebox may damage the pressurized boiler tubes and interior shell, potentially triggering structural failure, steam or water leakage, and/or a secondary boiler shell failure and steam explosion.
Alternatively, the ignition-limiting threshold is determined by performing a proper ignition test described in BSI PAS 95:2011 Hypoxic air fire prevention systems specification. [ 4 ] Smoke detectors are installed in protected volumes because, similar to gas suppression systems , hypoxic air does not prevent smoldering and pyrolyzing processes.