Search results
Results from the WOW.Com Content Network
In construction, a dwang (Scotland and New Zealand), [1] [2] [3] nogging piece, nogging, noggin or nog (England and Australia; all derived from brick nog), [4] [5] or blocking (North America), is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.
ISO 2848:1984, published by International Organization for Standardization, is an ISO standard used by the construction industry. [1]Adherence to the standard means that major dimensions such as grid lines on drawings, distances between wall centres or surfaces, widths of shelves and kitchen components are multiples of the basic module.
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
For premium support please call: 800-290-4726 more ways to reach us
Exterior wall studs are the vertical members to which the wall sheathing and cladding are attached. [14] They are supported on a bottom plate or foundation sill and in turn support the top plate. Studs usually consist of 1 + 1 ⁄ 2 -by- 3 + 1 ⁄ 2 -inch (38 mm × 89 mm) or 1 + 1 ⁄ 2 -by- 5 + 1 ⁄ 2 -inch (38 mm × 140 mm) lumber and are ...
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]
In 1985 IPC published a generic standard NC format, IPC-NC-349. Later XNC was designed, a simple strict subset of IPC-NC-349, designed not for driving machines but for exchanging drill information between CAD and CAM. They are collectively referred to as (PCB) NC files. [1] [2]