Search results
Results from the WOW.Com Content Network
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.
SPI lends itself to a "bus driver" software design. Software for attached devices is written to call a "bus driver" that handles the actual low-level SPI hardware. This permits the driver code for attached devices to port easily to other hardware or a bit-banging software implementation.
A system bus is a single computer bus that connects the major components of a computer system, combining the functions of a data bus to carry information, an address bus to determine where it should be sent or read from, and a control bus to determine its operation. The technique was developed to reduce costs and improve modularity, and ...
The host controller directs traffic flow to devices, so no USB device can transfer any data on the bus without an explicit request from the host controller. In USB 2.0, the host controller polls the bus for traffic, usually in a round-robin fashion. The throughput of each USB port is determined by the slower speed of either the USB port or the ...
Synchronous Data Link Control (SDLC) is a computer serial communications protocol first introduced by IBM as part of its Systems Network Architecture (SNA). SDLC is used as layer 2, the data link layer , in the SNA protocol stack .
If the link layer receiver detects a CRC error, the receiver notifies the transmitter via a flit on the return link of the pair and the transmitter resends the flit. The link layer implements flow control using a credit/debit scheme to prevent the receiver's buffer from overflowing. The link layer supports six different classes of message to ...
A driver provides a software interface to hardware devices, enabling operating systems and other computer programs to access hardware functions without needing to know precise details about the hardware being used. A driver communicates with the device through the computer bus or communications
Bidirectional communication with two unidirectional lines; Point-to-point or multi-slave networks; Maximum user data rate, transmission data depending on driver and line of e.g. RS-422: 10 MHz, 1 km; LVDS: 100 Mbit/s; Independent of the applied physical layer; CRC secured communication (sensor data and control data secured separately) [8]