enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Multimeter - Wikipedia

    en.wikipedia.org/wiki/Multimeter

    A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [ 2 ] [ 3 ] A typical multimeter can measure voltage , resistance , and current , [ 4 ] in which case can be used as a voltmeter , ohmmeter , and ammeter .

  3. List of electrical and electronic measuring equipment

    en.wikipedia.org/wiki/List_of_electrical_and...

    Capacitance meter: Measures the capacitance component Current clamp: Measures current without physical connection Curve tracer: Applies swept signals to a device and allows display of the response Cos Phi Meter: Measures the power factor Distortionmeter: Measures the distortion added to a circuit Electricity meter: Measures the amount of energy ...

  4. Ohmmeter - Wikipedia

    en.wikipedia.org/wiki/Ohmmeter

    Two terminals carry the current from and to the meter, while the other two allow the meter to measure the voltage across the resistor. In this arrangement, the power source is connected in series with the resistance to be measured through the external pair of terminals, while the second pair connects in parallel with the galvanometer which ...

  5. Electrical resistance and conductance - Wikipedia

    en.wikipedia.org/wiki/Electrical_resistance_and...

    Also called chordal or DC resistance This corresponds to the usual definition of resistance; the voltage divided by the current R s t a t i c = V I. {\displaystyle R_{\mathrm {static} }={V \over I}.} It is the slope of the line (chord) from the origin through the point on the curve. Static resistance determines the power dissipation in an electrical component. Points on the current–voltage ...

  6. Potentiometer - Wikipedia

    en.wikipedia.org/wiki/Potentiometer

    When a percentage is referenced with a non-linear taper, it relates to the resistance value at the midpoint of the shaft rotation. A 10% log taper would therefore measure 10% of the total resistance at the midpoint of the rotation; i.e. 10% log taper on a 10 kOhm potentiometer would yield 1 kOhm at the midpoint.

  7. Ohm - Wikipedia

    en.wikipedia.org/wiki/Ohm

    One of the functions of many types of multimeters is the measurement of resistance in ohms.. The ohm is defined as an electrical resistance between two points of a conductor when a constant potential difference of one volt (V), applied to these points, produces in the conductor a current of one ampere (A), the conductor not being the seat of any electromotive force.

  8. Four-terminal sensing - Wikipedia

    en.wikipedia.org/wiki/Four-terminal_sensing

    Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...

  9. List of resistors - Wikipedia

    en.wikipedia.org/wiki/List_of_resistors

    An ammeter shunt is a special type of current-sensing resistor, having four terminals and a value in milliohms or even micro-ohms. Current-measuring instruments, by themselves, can usually accept only limited currents. To measure high currents, the current passes through the shunt across which the voltage drop is measured and interpreted as ...