Search results
Results from the WOW.Com Content Network
The EDIS-8 module is used on the following vehicles equipped with the 4.6-liter V-8 Ford Modular engine between 1990 and 1997: Lincoln Town Car, Mark VIII; Ford Crown Victoria / Mercury Grand Marquis; Ford Thunderbird / Mercury Cougar; Ford Mustang; The EDIS-8 Module was also used in Some later 5.0L Ford Explorers until around 2002
A cheater plug, AC ground lifter or three-prong/two-prong adapter is an adapter that allows a NEMA 5-15P grounding-type plug (three prongs) to connect to a NEMA 1-15R non-grounding receptacle (two slots). [1]: 112 They are needed to allow appliances with 3-wire power cords to plug into legacy ungrounded (two slot) receptacles found in older ...
An IBM tabulating machine, such as the 402 or 407 series would have several counters available in different sizes. (For example, the IBM 402/403 had four sets each of 2, 4, 6 and 8 digit counters, labeled 2A, 2B, 2C, 2D, 4A, 4B etc.) Each counter had two counter control entries to specify either addition (plus) or subtraction (minus). If ...
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.
Moving heads connected to a plug-in box (center). In stage lighting, a plug-in box, plug box [1] or drop box [2] is a device, similar to a power strip, to distribute power to multiple lighting instruments, consisting of an inlet (either detachable or hard-wired), and multiple female outlet connectors or pigtails.
Tube sockets were typically mounted in holes on a sheet metal chassis and wires or other components were hand soldered to lugs on the underside of the socket. In the 1950s, printed circuit boards were introduced and tube sockets were developed whose contacts could be soldered directly to the printed wiring tracks.
There are a number of sizes listed below that appear to be quite similar, and while the tolerances of these connectors are typically indicated as ±0.05 or ±0.03 mm by the manufacturers, there is still ambiguity as to whether two sizes differing by only 0.05 mm (or where the specification is only given to the nearest 0.10 mm) warrants listing ...
Products covered by the standard include cord assemblies of a plug that mates with the standard cigarette receptacle found in automobiles. 6-volt cigarette lighter receptacle and plug. Receptacle inside diameter: 21.34–21.46 mm (median 21.4 mm) Plug body diameter: 21.08–21.23 mm (median 21.155 mm) 12-volt cigarette lighter receptacle and ...