Ads
related to: early dodge hemi speed equipment catalog
Search results
Results from the WOW.Com Content Network
Dodge's Hemi was introduced in 1953 as the Red Ram. [4] Dodge did not have a V8 engine until one was developed specifically for the line in 1953 based on the 1951 Chrysler hemi design, but downsized for these smaller cars. They have the smallest bore center spacing of any hemi engine at 4.1875 in (106.4 mm).
Borg-Warner T-10 — 4-speed longitudinal 1963 Dodge and Plymouth V8, except Hemi; Borg-Warner T-56 (also known as Tremec T-56) — 6-speed longitudinal 2004–2006 Dodge Ram SRT10; 1992–2002 Dodge Viper RT/10; 1996–2002 Dodge Viper GTS; 2003–2007 Dodge Viper SRT-10; Fiat C510 — 5-speed transaxle 2014–present Jeep Renegade (1.6L E.torQ)
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
The 440+6 and 426 Hemi were available, though this would be the last year for them. The tall axle ratios with the 8 3/4-inch Chrysler and Dana 60 rear ends, as well as the wide and close-ratio 4-speed transmissions, could be had with any of the engine choices, though few cars were built with the six-pack or Hemi engines. Aerodynamics were much ...
In the late 1970s, Chrysler designed the A404 TorqueFlite three-speed automatic transaxle for its front-wheel drive Dodge Omni and Plymouth Horizon subcompact cars. This transaxle would be upgraded in the 1980s into the A413 and A670 units, which were progressively heavier-duty, for Chrysler's K-cars and their derivatives, including the minivans.
Chrysler called the Hemi-powered Dodge trucks "Power Giant" in 1957, and introduced power steering and brakes, a three-speed automatic, and a 12-volt electrical system. From 1957 to 1959, Dodge offered the Sweptside pickup, a rival to the Chevrolet Cameo Carrier , but it never became a bestseller. [ 2 ]
Unlike Chrysler's contemporaneous hemi V8 engines, the Hemi-6's rocker arms are mounted on individual studs (similar to the Chevrolet "big block" V8), rather than on 2 separate rocker shafts as in all 1951-58 Hemis—Dodge, DeSoto, Imperial, and Chrysler "Firepower" and 1964-'71 Plymouth and Dodge 426 V8s. All Hemi-6s share a robust crankshaft ...
The Chrysler A engine is an OHV small-block V8 gasoline engine built by Chrysler from 1956 until 1967. It featured polyspherical combustion chambers, and was offered in displacements from 276.1 cu in (4.5 L) to 325.2 cu in (5.3 L), and in various high-power configurations.
Ads
related to: early dodge hemi speed equipment catalog