enow.com Web Search

  1. Ads

    related to: ethernet cable holder clips 4 u

Search results

  1. Results from the WOW.Com Content Network
  2. Attachment Unit Interface - Wikipedia

    en.wikipedia.org/wiki/Attachment_Unit_Interface

    In the case of incompatible fittings, the jackposts or sliding clip can be unscrewed and replaced, or adapter dongles and cables can be used. Electrically, the AUI's differential signals are designed for use with a 78 Ω cable and can transmit data between DTE and MAU at 10 Mbps over the standard's specified 50-meter length.

  3. Modular connector - Wikipedia

    en.wikipedia.org/wiki/Modular_connector

    An 8P8C modular plug. This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve). A modular connector is a type of electrical connector for cords and cables of electronic devices and appliances, such as in computer networking, telecommunication equipment, and audio headsets.

  4. Ethernet hub - Wikipedia

    en.wikipedia.org/wiki/Ethernet_hub

    4-port 10BASE-T Ethernet hub with selectable MDI-X/MDI port 8-port Ethernet hub with one 10BASE2 connector and eight 10BASE-T ports. An Ethernet hub, active hub, network hub, repeater hub, multiport repeater, or simply hub [a] is a network hardware device for connecting multiple Ethernet devices together and making them act as a single network segment.

  5. Registered jack - Wikipedia

    en.wikipedia.org/wiki/Registered_jack

    A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.

  6. Optical fiber connector - Wikipedia

    en.wikipedia.org/wiki/Optical_fiber_connector

    2.5×6.4 mm Pre-terminated cable assemblies; outdoor applications [15] MT-RJ: Mechanical Transfer Registered Jack or Media Termination - recommended jack [9] Latch, gendered [1] — 2.45×4.4 mm IEC 61754-18 Duplex multimode connections [E] MU Miniature unit [9] Latch, push-pull — 1.25 mm IEC 61754-6 Common in Japan [1] SC: Subscriber ...

  7. Ethernet crossover cable - Wikipedia

    en.wikipedia.org/wiki/Ethernet_crossover_cable

    A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...

  1. Ads

    related to: ethernet cable holder clips 4 u