Search results
Results from the WOW.Com Content Network
For example, AWG 12g is 2.1 mm, but SWG 12g is 2.6 mm. AWG 8g happens to be the same as SWG 10g. AWG 000g is 10.4 mm, but SWG 000g is 9.4 mm. In most discussions of body jewelry, sizes are specified by giving the gauge, usually abbreviated by the suffix "g", the same symbol as used for grams : "12g".
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
GSM is accountable for the linear metres and specific use of the fabric. The fabric weight is measured in grams. In the metric system, the mass per unit area of all types of textiles is expressed in grams per square metre (g/m 2). The gram (alternative spelling: gramme; SI unit symbol: g) is a metric system unit of mass.
This is a list of firearm cartridges that have bullets in the 9 millimeters (0.35 in) to 9.99 millimeters (0.393 in) caliber range. Case length refers to the round case length. OAL refers to the overall length of the loaded round. All measurements are given in millimeters, followed by the equivalent in inches between parentheses.
Convert from geodetic coordinates to geocentric coordinates: Calculation of x, y and z relative to the reference ellipsoid of surveying 7-parameter transformation (where x , y and z almost always change by a few hundred metres at most, and distances by a few mm per km).
The typical torque converter of the time was about 11.5in. long and the torque multiplication ratio was about 1.5 to 1. The N360/N600 torque converter was about 5.5in. long and achieved a torque multiplication of over 2.2 to 1. The first Civic was equipped with a manually changed hydraulically engaged two-speed transmission with a torque converter.
One of the functions of many types of multimeters is the measurement of resistance in ohms.. The ohm is defined as an electrical resistance between two points of a conductor when a constant potential difference of one volt (V), applied to these points, produces in the conductor a current of one ampere (A), the conductor not being the seat of any electromotive force.
The E.626 class is the result of a requirement issued in 1926 by the Ferrovie dello Stato (FS, Italian Railways) for a new locomotive to be used under the new 3,000 V DC line being built between Foggia and Benevento.