Search results
Results from the WOW.Com Content Network
Aquifer test (or a pumping test) is a field experiment in which a well is pumped at a controlled rate and the aquifer's response (drawdown) is measured in one or more observation wells. [ 5 ] Cone of depression is a conically-shaped depression that is produced in a water table as a result of pumping water from a well at a given rate.
An adjustable box for measuring water flow in miner's inches. The miner's inch is a unit of flow in terms of volume per unit time, usually in relation to the flow of water. The definition of a miner's inch varies by location. In hydraulic mining and some forms of placer mining, as well as ore dressing, a large and regular supply of water is needed.
In hydrology, a well test is conducted to evaluate the amount of water that can be pumped from a particular water well.More specifically, a well test will allow prediction of the maximum rate at which water can be pumped from a well, and the distance that the water level in the well will fall for a given pumping rate and duration of pumping.
Conventional airlift pumps have a flow rate that is very limited. The pump is either on or off. It is very difficult to get a wide range of proportional flow control by varying the volume of compressed air. This is a dramatic disadvantage in some parts of a small wastewater treatment plant, such as the aerator. [5] the suction is limited.
In most contexts a mention of rate of fluid flow is likely to refer to the volumetric rate. In hydrometry, the volumetric flow rate is known as discharge. Volumetric flow rate should not be confused with volumetric flux, as defined by Darcy's law and represented by the symbol q, with units of m 3 /(m 2 ·s), that is, m·s −1. The integration ...
This depth is converted to a flow rate according to a theoretical formula of the form = where is the flow rate, is a constant, is the water level, and is an exponent which varies with the device used; or it is converted according to empirically derived level/flow data points (a "flow curve"). The flow rate can then be integrated over time into ...
The flow coefficient of a device is a relative measure of its efficiency at allowing fluid flow. It describes the relationship between the pressure drop across an orifice valve or other assembly and the corresponding flow rate. Mathematically the flow coefficient C v (or flow-capacity rating of valve) can be expressed as
In hydrology, discharge is the volumetric flow rate (volume per time, in units of m 3 /h or ft 3 /h) of a stream. It equals the product of average flow velocity (with dimension of length per time, in m/h or ft/h) and the cross-sectional area (in m 2 or ft 2). [1] It includes any suspended solids (e.g. sediment), dissolved chemicals like CaCO